Despite being a long-time POD HD user, I recently ran into a problem, that seemed really odd to me. In the POD: I have inputs set to Input 1: "Guitar", Input 2: "Variax", to avoid signal doubling. There is one single amp in the patch, in mono. Mixer set to both channels at 0 degrees (center). There's 1 FX block post mixer, which is reverb. I run only 1 xlr (left or right) as mono send to FOH board. The channel in the FOH board has got pan set to center. And I get only one channel working in the FOH. To have guitar in both channels, I have to set input 2 to "same" or "guitar", so there's sound in both sides of the FOH system. I don't f***ng get it. The outs are mono per se, unless they're panned in the Mixer block, right? There's a mono patch, I send mono signal from the XLR out to a mono channel on the board, HOW ON THE EARTH the sound is only in one channel?