Line6Hugo

"Hello,   If the pedal became loose, you can open the bottom of the unit and tighten the bolt that is holding it in place to regain the resi"

"Hello,   The amp is not based on any other existing amp as it was designed as a Line 6 original amp model with ultra-high gain.   Regards,"

"It sounds like a hardware problem with the device and it would need to be serviced at an authorized service center:   http://line6.com/serv"

"Please try re-installing all of the POD Farm software and drivers from the website:   http://line6.com/software/   Please make sure to che"

"This sounds like a connection issue.  I would suggest testing all of the computer's USB ports, and remove all other USB devices, especially"

"Please check to see how much remaining recording time you have left on the unit.  This can prevent you from being able to record onto the un"

"If the switches no longer respond on the POD X3 Live, it would need to be serviced at an authorized service center:   http://line6.com/serv"

"sharpin,   The Floor POD Plus will not control the Spider IV amp.  It will act like just an effect processor before the Spider's own proces"

"Hello,   To work properly, speaker cabs need to be connected to a power amp to provide the power to drive the speakers properly.  The POD X"

"Looking at your account, you have a POD Farm 2 license on the POD X3 as well.   Please use the License Manager 1.03 software to authorize y"

"Please try this using a different web browser to see if it acts any differently.  If the problem persists, please use the contact technical"

"It's not necessary to register the unit to use it, but greatly appreciated if you need technical support.   Regards,   Line6Hugo"

"The Digital Sync switch on the front of the unit has been set to digital.  Just move the switch over to 44.1 or 48 and it show work again.  "